Automotive Accessories

Jeep Builder Turns a Ford 9-Inch Axle Into a Budget Rear Portal Setup

Zeph Gage paired Humvee geared hubs and adapters with an upside-down Ford 9-inch differential to add about six inches of clearance to his Jeep XJ at roughly a fifth of the usual portal-axle cost.

Mei-Lin ChenNovember 17, 20265 min read2 views

Concept illustration of an off-road rear axle with an inverted differential centre section and a geared portal hub at the wheel end, rendered on a workshop floor.

Zeph Gage has built a portal axle for the rear of his Jeep XJ at roughly one-fifth the cost of a typical off-the-shelf set, a build documented in a video from Outdoor Auto. A conventional pair of portal axles from specialists such as 74Weld runs about $20,000; Gage's assembly instead combines a Ford 9-inch axle housing, geared hubs sourced from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters.

Portal axles are conceptually simple but change a vehicle's geometry substantially. As Andrew Collins described after driving portal-equipped Ineos Grenadiers in the Arctic, the design places a stack of gears behind each driven wheel instead of hanging shafts and other components below the transmission and transfer case. That lets the axle shafts sit high, leaving very little hardware below the frame line; paired with tall tires, the arrangement opens up enough room to sit under the vehicle.

Gage's version is a rear-only installation, and much of the cost saving comes from how he dealt with the direction of rotation.

Correcting rotation with an upside-down differential

Two-gear portals of the Humvee type take the rotation of the input shaft and reverse it. To make that work with a Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the correct direction, then bolted a Yukon Gear and Axle third member to it. The arrangement effectively creates a budget high-pinion unit out of low-pinion parts that have simply been turned over.

Beyond the six inches of added clearance, the layout also retains full shock travel, something the builder notes is tricky to achieve with portal axles, while reducing stress on the differential itself. The result is described as effectively bulletproof.

Why the front axle stays conventional

Fitting a portal only at the rear is a common trick in the remote-control rock crawler scene. By keeping the solid axle up front, Gage avoided the packaging constraints that typically arise when portal axles are upfitted to a vehicle that never had them from the factory. He also did not have to restrict shock travel to make the hardware fit, and ride height was not raised to an extreme level, which the build presents as a best-of-both-worlds arrangement.

Custom fabrication rather than a kit

The setup is not an off-the-shelf solution. Gage did substantial custom work, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric emergency brake solenoid, and partly for clearance reasons.

The finished Jeep can drive over a five-gallon bucket and still have several inches of clearance to spare, which means the rear end will not hang up on obstacles the front end can simply steer around. Gage also matched gearing between the front and rear axles; the Outdoor Auto video covers those specifics.