WITT Gas Controls plans to exhibit at FABTECH 2026, scheduled for October 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada. At Booth S46114, the company intends to discuss its MEM+ gas mixers, dome pressure regulators and gas safety valves, focusing on precise mixing, stable pressure and system protection for industrial gas systems. The company says attendees are invited to the booth to discuss applications that require controlled gas mixtures and protective equipment.
The MEM+ series is designed to mix two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen. WITT describes the mixers as suitable for a wide range of industrial applications. Electronically operated motorized proportional valves permit adjustments in 0.1 percent increments. According to the company, the system can reach a desired gas mixture in less than three seconds, with accuracy better than ±1% absolute.
System integration and pressure control
Seven interface options, including Ethernet, OPC UA and PROFINET, are intended to support integration into existing systems. Users can operate the mixers remotely through a PC, PLC or machine controller, or directly through a touchscreen interface. Pressure equalization compensates for supply pressure fluctuations. Continuous inlet pressure monitoring and pressure alarms support safe, reliable operation, while an integrated buffer tank accommodates fluctuating flow rates.
The MEM+ enclosure is described as splash-proof and made of brushed stainless steel. Maximum inlet pressure is 20 bar, and maximum outlet pressure is 10 bar. These specifications indicate the range within which the mixer is designed to operate; they are product ratings provided by WITT, not results from an independently verified test.
Regulators and safety valves
WITT also plans to highlight dome pressure regulators that use optimized pilot pressure regulators. The design is intended to maintain stable working pressure despite changes in flow rates and inlet pressures, supporting consistent process performance and product quality. The improvements can be retrofitted to existing WITT dome pressure regulators without replacing the complete system.
For backflow protection, the company will discuss ULTRA non-return valves. WITT says these combine low opening pressures, tight sealing and minimal flow resistance. ULTRAVENT safety relief valves are designed to protect gas systems against excessive pressure and respond to pressure increases as low as 5 mbar.
The planned FABTECH presence places the products in the context of industrial gas handling, where accurate mixture ratios, stable pressure and protection against backflow or overpressure are key operating requirements. WITT’s booth discussion is expected to cover how the three product groups address those functions, based on the information released by the company.
